Chrysler Town and Country 2003 Owner's Manual page 889

INCOMPLETE LATCH CINCH - NO PAWL TRANSITION —
TEST
3 Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Sliding Door Latch Sensing Switch connector (latch assembly).
Measure the resistance of the Ground wires (both) between the PSD C2 connector
(cavity 20) and the Sliding Door Latch Sensing Switch connector.
Wiggle the harness while observing the ohmmeter.
Is the resistance below 5.0 ohms on both ground wires?
Yes → Go To 4
→ Repair the Ground wire for an open.
No
4 Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Sliding Door Latch Sensing Switch connector (latch assembly).
Measure the resistance of the Pawl Switch Sense wire between the PSD C2 connector
and the Sliding Door Latch Sensing Switch connector.
Wiggle the harness while observing the ohmmeter.
Is the resistance below 5.0 ohms?
Yes → Go To 5
→ Repair the Pawl Switch Sense wire for an open.
No
5 Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Sliding Door Latch Sensing Switch connector (latch assembly).
Measure the resistance between ground and the Pawl Switch Sense circuit.
Wiggle the harness while observing the ohmmeter.
Is the resistance below 1000.0 ohms?
Yes → Repair the Pawl Switch Sense wire for a short to ground.
→ Go To 6
No
6 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Pawl Switch (latch assembly).
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - SLIDING
865
Continued
APPLICABILITY
All
All
All
All