Chrysler Town and Country 2003 Owner's Manual page 818

POWER DOOR LOCKS/RKE
RKE PROGRAM LINE OUTPUT OPEN —
TEST
3 Turn the ignition off.
Disconnect the Remote Keyless Entry Module connector.
Disconnect the Body Control Module C4 connector.
Measure the resistance of the RKE Module Program Enable circuit between the RKE
Module connector and the BCM C4 connector.
Is the resistance below 5.0 ohms?
Yes → Go To 4
→ Repair the RKE Module Program Enable wire for an open
No
4 Turn the ignition off.
Disconnect the Remote Keyless Entry Module connector.
Disconnect the Body Control Module C4 connector.
Measure the resistance of the RKE Module Program Enable circuit to ground.
Is the resistance below 1000.0 ohms?
Yes → Repair the RKE Module Program Enable wire for a short to
→ Go To 5
No
5 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Remote Keyless Entry Module.
Perform BODY VERIFICATION TEST - VER 1.
Continued
794
APPLICABILITY
All
All
All