MEMORY SEAT
REAR RISER SENSOR OUT OF RANGE LOW —
TEST
8
Turn ignition off.
Disconnect the Memory Seat Mirror Module C2 connector.
Disconnect the Driver Power Seat Rear Riser Position Sensor connector.
Measure the resistance of the Seat Sensor 5 Volt Supply wire between the Rear Riser
Sensor connector and the C2 connector.
Is the resistance below 5.0 ohms?
Yes → Go To 9
No
9
If there are no possible cause remaining, view repair.
Repair
ACTION
→ Repair the Seat Sensor 5 Volt Supply circuit for an open.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Replace the Memory Seat Mirror Module.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Continued
714
APPLICABILITY
All
All