Chrysler Town and Country 2003 Owner's Manual page 752

MEMORY SEAT
RIGHT MIRROR HORIZONTAL SENSOR OUT OF RANGE HIGH —
Continued
TEST
3 Turn the ignition off.
Disconnect the Right Power Mirror connector.
Measure the resistance of the Right Mirror Sensor Ground circuit in the harness
connector to ground.
Is the resistance below 5.0 ohms?
Yes → Go To 4
→ Go To 5
No
4 If there are no possible causes remaining, view repair.
Repair
5 Turn the ignition off.
Disconnect the Right Power Mirror connector.
Disconnect the Memory Seat Mirror Module C1 connector.
Measure the resistance of Right Mirror Sensor Ground circuit between the Memory
Seat Mirror Module connector and the Right Power Mirror connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Memory Seat Mirror Module.
→ Repair the open Sensor Ground circuit.
No
6 Turn the ignition off.
Disconnect the Right Power Mirror connector.
Disconnect the Memory Seat Mirror Module C1 connector.
Turn the ignition on.
Measure the voltage of Right Mirror Horizontal Position Signal circuit.
Is there any voltage present?
Yes → Repair the Right Mirror Horizontal Position Signal circuit for a
→ Go To 7
No
7 Turn the ignition off.
Disconnect the Memory Seat Mirror Module C1 connector.
Disconnect the Right Power Mirror connector.
Measure the resistance of the Right Mirror Horizontal Position Signal circuit from
the Right power mirror connector to the Memory Seat Mirror Module connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Memory Seat Mirror Module.
→ Repair the open Right Mirror Horizontal Position Signal wire.
No
ACTION
Replace the Right Power Mirror.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
short to voltage.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
728
APPLICABILITY
All
All
All
All
All