Right Front Turn Signal Output Open - Chrysler Town and Country 2003 Owner's Manual

EXTERIOR LIGHTING
Symptom:

RIGHT FRONT TURN SIGNAL OUTPUT OPEN

When Monitored and Set Condition:
RIGHT FRONT TURN SIGNAL OUTPUT OPEN
When Monitored: Ignition and right turn signal On.
Set Condition: When the output voltage status is LOW.
INTERMITTENT CONDITION
GROUND CIRCUIT OPEN
TURN SIGNAL LAMP OPEN
RIGHT FRONT TURN SIGNAL DRIVER CIRCUIT OPEN
BODY CONTROL MODULE
INTELLIGENT POWER MODULE
TEST
1 Turn the ignition on.
With the DRBIII , clear all BCM DTC's.
Actuate the Turn Signals.
With the DRBIII , read the DTC information.
Does the DRBIII read: Right Front Turn Signal Output Open?
Yes → Go To 2
→ The condition that caused the symptom is currently not present.
No
2 Turn the ignition off.
Disconnect the Right Front Turn Signal harness connector.
Using a 12-volt test light connected to 12-volts, check the ground circuit.
Does the test light illuminate brightly?
Yes → Go To 3
→ Repair the Ground Circuit.
No
POSSIBLE CAUSES
ACTION
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced,pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
482
APPLICABILITY
All
All