Chrysler Town and Country 2003 Owner's Manual page 891

INCOMPLETE LATCH CINCH - OVERCURRENT —
TEST
3 Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Cinch/Release Motor connector.
Measure the resistance of the Cinch/Release Motor Latch Driver circuit between the
Sliding Door Control Module C2 connector and the Cinch/Release Motor connector.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 5.0 ohms?
Yes → Go To 4
→ Repair the Cinch/Release Motor Latch Driver wire for an open.
No
4 Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Cinch/Release Motor connector.
Measure the resistance of the Cinch/Release Motor Unlatch Driver circuit between
the Sliding Door Control Module C2 connector and the Cinch/Release Motor connec-
tor.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 5.0 ohms?
Yes → Go To 5
→ Repair the Cinch/Release Motor Unlatch Driver wire for an open.
No
5 Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Cinch/Release Motor connector.
Measure the resistance between ground and the Cinch/Release Motor Latch Driver
circuit.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 1000.0 ohms?
Yes → Go To 6
→ Repair the Cinch/Release Motor Latch Driver wire for a short to
No
6 Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Cinch/Release Motor connector.
Measure the resistance between ground and the Cinch/Release Motor Unlatch Driver
circuit.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 1000.0 ohms?
Yes → Go To 7
→ Repair the Cinch/Release Motor Unlatch Driver wire for a short to
No
7 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Latch Assembly.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - SLIDING
867
Continued
APPLICABILITY
All
All
All
All
All