Chrysler Town and Country 2003 Owner's Manual page 425

*NO RESPONSE FROM POWER LIFTGATE MODULE —
TEST
6 Turn the ignition off.
Disconnect the Body Control Module C2 harness connector.
Disconnect the Power Liftgate Module C2 harness connector.
Measure the resistance between ground and the Liftgate Module Wake Up Signal
circuit.
Is the resistance below 100.0 ohms?
Yes → Repair the Liftgate Module Wake Up Signal wire for a short to
→ Go To 7
No
7 If there are no possible causes remaining, view repair.
Repair
8 Turn the ignition off.
Disconnect the Body Control Module C2 harness connector.
Disconnect the Power Liftgate Module C2 harness connector.
Measure the resistance of the Liftgate Module Wake Up Signal circuit between the
BCM C2 connector and the Power Liftgate Module C2 connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module in accordance with the service
→ Repair the Liftgate Module Wake Up Signal wire for an open.
No
ACTION
ground.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Power Liftgate Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
information.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
401
COMMUNICATION
Continued
APPLICABILITY
All
All
All