Chrysler Town and Country 2003 Owner's Manual page 883

PINCH SENSOR SIGNAL CIRCUIT SHORT TO GROUND —
TEST
4 Remove the Power Liftgate Motor trim panel.
Remove the Liftgate trim panel.
Disconnect the Power Liftgate Module C2 connector.
Disconnect the Right Pinch Sensor connector
Measure the resistance between ground and the Pinch Sensor Signal circuit.
Is the resistance below 100.0 ohms?
Yes → Go To 5
→ Replace the Right Pinch Sensor.
No
5 Remove the Liftgate trim panel.
Disconnect the Right Pinch Sensor connector.
Disconnect the Left Pinch Sensor connector.
Measure the resistance between ground and the Right Pinch Sensor Signal circuit.
Is the resistance below 1000.0 ohms?
Yes → Repair the Right Pinch Sensor Signal wire for a short to ground.
→ Go To 6
No
6 Remove the Power Liftgate Motor trim panel.
Remove the liftgate trim panel.
Disconnect the Power Liftgate Module C2 connector.
Disconnect the Left Pinch Sensor connector
Measure the resistance between ground and the Pinch Sensor Signal circuit.
Is the resistance below 100.0 ohms?
Yes → Go To 7
→ Replace the Left Pinch Sensor.
No
7 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Repair the Pinch Sensor Signal wire for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - LIFTGATE
859
Continued
APPLICABILITY
All
All
All
All