Horizontal Rearward Position Stuck - Chrysler Town and Country 2003 Owner's Manual

Table of Contents

Advertisement

Symptom:

HORIZONTAL REARWARD POSITION STUCK

When Monitored and Set Condition:
HORIZONTAL REARWARD POSITION STUCK
When Monitored: Continuously when the PCI bus is active.
Set Condition: If the seat switch is active for 30 seconds, this code will set and the
Memory Seat Mirror Module will ignore the input until the state has changed. Once the
stuck condition is removed, the seat will resume to normal operation. Code will remain for
50 ignition cycles.
STORED DIAGNOSTIC TROUBLE CODE
DRIVER POWER SEAT SWITCH
SEAT HORIZONTAL REARWARD SWITCH SENSE WIRE SHORT TO VOLTAGE
MEMORY SEAT MIRROR MODULE
TEST
1
With the DRBIII , erase the DTC from Memory Seat Mirror Module.
Operate the driver's power seat and memory system.
Turn the ignition switch to the Off position then start the engine and let run for one
minute.
With the DRB check for the same DTC to reset in the MSMM.
Did the same DTC reset?
Yes → Go To 2
→ Using the wiring diagram/schematic as a guide, inspect the
No
2
Disconnect the Power Seat Switch connector.
Measure the voltage of the Seat Horizontal Rearward Switch Sense circuit.
Is there any voltage present?
Yes → Go To 3
→ Replace the Power Seat Switch.
No
POSSIBLE CAUSES
ACTION
wiring and connectors for an intermittent condition.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
685
MEMORY SEAT
APPLICABILITY
All
All

Advertisement

Table of Contents
loading

This manual is also suitable for:

Voyager 2003Caravan 2003

Table of Contents