PINCH SENSOR CIRCUIT OPEN —
TEST
7
Remove the Power Liftgate Motor trim panel.
Remove the liftgate trim panel.
Disconnect the Power Liftgate Module C2 connector.
Disconnect the Liftgate Left Pinch Sensor connector.
Measure the resistance of the Pinch Sensor Signal circuit between the PLG C2
connector and the Liftgate Left Pinch Sensor connector.
Is the resistance below 5.0 ohms?
Yes → Test Complete.
→ Repair the Pinch Sensor Signal wire for an open.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - LIFTGATE
Continued
857
APPLICABILITY
All