Chrysler Town and Country 2003 Owner's Manual page 637

IGNITION START INPUT WIRING —
TEST
3 Turn the ignition off.
Gain access to the bottom of the Fuse and Relay Center.
Disconnect connector C9 from the Fuse and Relay Center.
Measure the resistance of the Fused Ignition Switch Output circuit between the FCM
connector cavity 37 and the Fuse and Relay Center connector C9 cavity 2.
Is the resistance below 5.0 ohms?
Yes → Repair the Fused Ignition Switch Output (Start) circuit for an
→ Replace the Fuse and Relay Center.
No
ACTION
open between the Fuse and Relay Center and the ignition switch.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
IGNITION, POWER, ACCESSORY
Continued
613
APPLICABILITY
All