Chrysler Town and Country 2003 Owner's Manual page 951

RIGHT B-PILLAR SWITCH INPUT OPEN OR SHORT TO VOLTAGE —
Continued
TEST
4 Disconnect the Body Control Module C3 connector.
Disconnect the Right B-Pillar Switch connector.
Measure the resistance of the Right Sliding Door Pillar Switch Mux circuit between
the BCM C3 connector and the Right B-Pillar Switch connector.
Is the resistance below 5.0 ohms?
Yes → Go To 5
→ Repair the Right Sliding Door Pillar Switch Mux wire for an open.
No
5 Disconnect the Body Control Module C3 connector.
Measure the resistance between Right Sliding Door Pillar Switch Mux circuit and
ground.
Is the resistance below 20500.0 ohms?
Yes → Replace the Body Control Module.
→ Go To 6
No
6 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Replace the B-Pillar Switch.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - SLIDING
927
APPLICABILITY
All
All
All