Table of Contents
Advertisement
POWER DOORS - SLIDING
Symptom:
INCOMPLETE POWER CLOSE - TIME OUT
When Monitored and Set Condition:
INCOMPLETE POWER CLOSE - TIME OUT
When Monitored: Anytime the Power Sliding Door is operating in the closing direction.
Set Condition: The power close operation was not completed within 20 seconds. This may
be caused by very high opening effort. A weak hall effect signal, low motor output or
defective clutch could also set this code.
DTC PRESENT
BINDING DOOR
MOTOR/CLUTCH ASSEMBLY
TEST
1
With the DRBIII , record and erase DTC's.
Turn the ignition off, wait 10 seconds, then turn the ignition on.
Operate the power sliding door several times from stop to stop - if possible.
With the DRBIII , read ACTIVE DTCs.
Does the DRBIII display INCOMPLETE POWER CLOSE - TIME-OUT?
Yes → Go To 2
→ Using the wiring diagram/schematic as a guide, inspect the
No
2
Examine the door for proper fit and alignment, loose/ hard or torn seals, worn teeth
on the rack and gear (lower drive unit) or anything that would cause an obstruction
to proper operation.
Manually operate the sliding door of a known good vehicle or the other sliding door
and notice the effort needed.
Compare the effort needed on the disabled door.
Does it take more effort to operate the door than it should?
Yes → Refer to Service information for the related symptom(s).
→ Replace the Motor/Clutch Assembly.
No
POSSIBLE CAUSES
ACTION
wiring and connectors for an intermittent condition. Operate the
door several times and check for any binding or other obstruc-
tions.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
892
APPLICABILITY
All
All
Advertisement
Table of Contents
