POWER DOOR LOCKS/RKE
LOCK OUTPUT FAILURE —
TEST
6
Disconnect the Body Control Module C2 connector.
Disconnect the Left Sliding Door Lock Motor connector.
Measure the resistance between ground and the Left Sliding Door Lock Driver
circuit.
Is the resistance below 1000.0 ohms?
Yes → Repair the Left Sliding Door Lock Driver wire for a short to
→ Replace the Left Sliding Door Lock Motor (Latch assy.)
No
Continued
ACTION
ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
778
APPLICABILITY
All