No Response From Right Siacm - Chrysler Town and Country 2003 Owner's Manual

COMMUNICATION
Symptom:

*NO RESPONSE FROM RIGHT SIACM

INTERROGATE FCM
GROUND CIRCUIT OPEN
SIACM RUN/START DRIVER CIRCUIT OPEN
PCI BUS CIRCUIT OPEN
RIGHT SIDE IMPACT AIRBAG CONTROL MODULE
TEST
1 Turn the ignition on.
With the DRBIII , check the FCM for any DTC's.
Are any FCM DTC's present?
Yes → Refer to the appropriate category and perform the symptom.
→ Go To 2
No
2 Ensure that the battery is fully charged.
Warning: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Right Side Impact Airbag Control Module harness connector.
Connect the appropriate Load Tool SIACM Adapter to the SIACM connector.
Using a 12-volt test light connected to 12-volts, probe the ground circuit.
Is the test light illuminated?
Yes → Go To 3
→ Repair the Ground circuit for an open.
No
Note: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
3 Warning: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Right Side Impact Airbag Control Module harness connector.
Connect the appropriate Load Tool SIACM Adapter to the SIACM connector.
Turn the ignition on and then reconnect the Battery.
Measure the voltage of the SIACM Run/Start Driver circuit.
Is the voltage above 6.0 volts?
Yes → Go To 4
→ Repair the SIACM Run/Start Driver circuit for an open.
No
Note: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
POSSIBLE CAUSES
ACTION
Perform AIRBAG VERIFICATION TEST - VER 1.
Perform AIRBAG VERIFICATION TEST - VER 1.
Perform AIRBAG VERIFICATION TEST - VER 1.
404
APPLICABILITY
All
All
All