IGNITION, POWER, ACCESSORY
RUN/START HARDWARE INPUT FAILURE —
TEST
3
Turn the ignition off.
Gain access to the Body Control Module C2 connector.
While back probing, measure the voltage of the Fused Ignition Switch Output
(Run/Start) circuit.
Is the voltage above 10.0 volts?
Yes → Repair the Fused Ignition Switch Output circuit for an open.
→ Replace the Body Control Module in accordance with the service
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
information.
Perform BODY VERIFICATION TEST - VER 1.
Continued
618
APPLICABILITY
All