Left Mirror Horizontal Sensor Out Of Range Low - Chrysler Town and Country 2003 Owner's Manual

Symptom:

LEFT MIRROR HORIZONTAL SENSOR OUT OF RANGE LOW

When Monitored and Set Condition:
LEFT MIRROR HORIZONTAL SENSOR OUT OF RANGE LOW
When Monitored: Continuously when the PCI bus is active.
Set Condition: This code is set when the mirror sensor feedback to the MSMM is less than
the mirror out of range low value stored in EEPROM. Code will remain for 50 ignition
cycles.
MSMM HORIZONTAL POSITION LOW
STORED DIAGNOSTIC TROUBLE CODE
LEFT MIRROR HORIZONTAL POSITION SIGNAL WIRE SHORT TO GROUND
LEFT POWER MIRROR
TEST
1 With the DRBIII , erase the DTC from Memory Seat Mirror Module.
Operate the driver's power seat and memory system.
Turn the ignition switch to the Off position then start the engine and let run for one
minute.
With the DRB check for the same DTC to reset in the MSMM.
Did the same DTC reset?
Yes → Go To 2
→ Using the wiring diagram/schematic as a guide, inspect the
No
2 Turn the ignition off.
Disconnect the Left Power Mirror connector.
Turn the ignition on.
Measure the voltage of the Left Mirror Horizontal Position Signal circuit in the Left
Power Mirror harness connector.
Is the voltage between 4.5 and 5.5 volts?
Yes → Replace the Left Power Mirror.
→ Go To 3
No
POSSIBLE CAUSES
ACTION
wiring and connectors for an intermittent condition.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
695
MEMORY SEAT
APPLICABILITY
All
All