Both Power Folding Mirrors Do Not Fold (Export Only) - Chrysler Town and Country 2003 Owner's Manual

POWER MIRROR
Symptom:
*BOTH POWER FOLDING MIRRORS DO NOT FOLD (EXPORT
ONLY)
RELATED DIAGNOSTIC TROUBLE CODES
GROUND CIRCUIT OPEN
POWER FOLDING MIRROR SWITCH
FOLDING MIRROR SWITCH SIGNAL OPEN
BODY CONTROL MODULE
TEST
1 With the DRBIII , read DTCs.
Does the DRBIII display any related DTC's?
Yes → Refer to symptom list for problems related to Power Folding
→ Go To 2
No
2 Disconnect the Power Folding Mirror switch connector
Check connectors - Clean/repair as necessary.
Measure the resistance of the ground circuit.
Is the resistance below 5.0 ohms?
Yes → Go To 3
→ Repair the ground circuit for an open.
No
3 Disconnect the Power Folding Mirror Switch connector.
Check connectors - Clean/repair as necessary.
With the DRBIII in Inputs/Outputs, read the Foldaway Switch state.
Connect a jumper wire between the Folding Mirror Switch Signal circuit and ground.
Does the DRBIII display change?
Yes → Replace the Power Folding Mirror Switch.
→ Go To 4
No
4 Disconnect the Power Folding Mirror Switch connector.
Disconnect the BCM C4 harness connector.
Check connectors - Clean/repair as necessary.
Measure the resistance of the Folding Mirror Switch Signal circuit between the BCM
C4 connector and the Power Folding Mirror Switch connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module.
→ Repair the Folding Mirror Switch Signal circuit for an open.
No
POSSIBLE CAUSES
ACTION
Mirrors.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
940
APPLICABILITY
All
All
All
All