Right B-Pillar Switch Input Open Or Short To Voltage - Chrysler Town and Country 2003 Owner's Manual

POWER DOORS - SLIDING
Symptom:

RIGHT B-PILLAR SWITCH INPUT OPEN OR SHORT TO VOLTAGE

When Monitored and Set Condition:
RIGHT B-PILLAR SWITCH INPUT OPEN OR SHORT TO VOLTAGE
When Monitored: Continuously when the BCM is awake.
Set Condition: When the BCM senses an input greater than 4.8 volts for over 10 seconds.
DTC PRESENT
RIGHT SLIDING DOOR PILLAR SWITCH MUX CIRCUIT SHORT TO VOLTAGE
GROUND CIRCUIT OPEN
RIGHT SLIDING DOOR PILLAR SWITCH MUX WIRE OPEN
RIGHT B-PILLAR SWITCH OPEN
BODY CONTROL MODULE - RIGHT SLIDING DOOR PILLAR SWITCH OPEN
TEST
1 With the DRBIII , record and erase DTC's.
Turn the ignition off, wait 10 seconds, then turn the ignition on.
Operate the right power sliding door from the Right B-Pillar Switch.
With the DRBIII , read DTCs.
Does the DRBIII display RIGHT B-PILLAR SWITCH INPUT OPEN?
Yes → Go To 2
→ Using the wiring diagram/schematic as a guide, inspect the
No
2 Disconnect the Body Control Module C3 connector.
Measure the voltage between Right Sliding Door Pillar Switch Mux circuit and
ground.
Is there any voltage present?
Yes → Repair the Right Sliding Door Pillar Switch Mux circuit for a
→ Go To 3
No
3 Disconnect the B-Pillar Switch connector.
Using a 12-volt test light connected to 12-volts, check the Ground circuit in the
B-Pillar Switch connector.
Does the test light illuminate brightly?
Yes → Go To 4
→ Repair the Ground circuit for an open.
No
POSSIBLE CAUSES
ACTION
wiring and connectors for an intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
short to voltage.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
926
APPLICABILITY
All
All
All