Chrysler Town and Country 2003 Owner's Manual page 120

AIRBAG
LOSS OF IGNITION RUN - START —
TEST
3 Select the FCM active RUN - START DTC displayed on the DRB.
1. ORC RUN-START DRIVER OPEN
2. ORC RUN-START DRIVER OVER VOLTAGE
3. ORC RUN-START DRIVER SHORT TO GROUND
4. ORC RUN-START DRIVER OVER CURRENT
5. ORC RUN-START DRIVER OVER TEMP
6. SIACM RUN - START DRIVER OPEN
7. SIACM RUN - START DRIVER OVER VOLT
8. SIACM RUN - START SHORT TO GROUND
9. SIACM RUN - START DRIVER OVER TEMP
10. SIACM RUN-START DRIVER OVER CURRENT
4 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED.
Disconnect the Airbag Control Module connector.
Connect the appropriate Load Tool ACM Adaptor to the Airbag Control Module
connector(s).
Connect a test light to ground and the ORC Run-Start Driver circuit at the ACM
adaptor.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
Turn the ignition off, wait 90 seconds, then turn the ignition on.
With the DRBIII , read the active FCM DTC's.
Does the DRB show an active ORC RUN - START DRIVER OPEN code?
Yes → Go To 5
→ WARNING: MAKE SURE THE BATTERY IS DISCONNECTED,
No
ACTION
Go To 4
Go To 15
Go To 7
Go To 7
Go To 7
Go To 10
Go To 15
Go To 16
Go To 16
Go To 16
THEN WAIT TWO MINUTES BEFORE PROCEEDING. Replace
the Airbag Control Module in accordance with Service Instruc-
tions.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
96
APPLICABILITY
All
All