Tcm Messages Not Received - Chrysler Town and Country 2003 Owner's Manual

COMMUNICATION
Symptom:

TCM MESSAGES NOT RECEIVED

When Monitored and Set Condition:
TCM MESSAGES NOT RECEIVED
When Monitored: With the ignition in run, and the IOD fuse installed.
Set Condition: The BCM does not receive any messages from the Transmission Control
Module (TCM) for at least 5 seconds.
ATTEMPT TO COMMUNICATE WITH THE TCM
BODY CONTROL MODULE
TEST
1 Turn the ignition on.
With the DRBIII , attempt to communicate with the Transmission Control Module.
Was the DRBIII able to I/D or communicate with the TCM?
Yes → Go To 2
→ Refer to the Communication category for the related symptom(s).
No
2 With the DRBIII , erase DTC's.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRBIII , read DTC's.
Did this DTC reset?
Yes → Replace the Body Control Module in accordance with the service
→ Test Complete.
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
information.
Perform BODY VERIFICATION TEST - VER 1.
360
APPLICABILITY
All
All