Table of Contents
Advertisement
POWER DOORS - SLIDING
INCOMPLETE LATCH RELEASE - FULL OPEN SWITCH FAILURE —
Continued
TEST
7
Disconnect the Power Sliding Door C2 connector.
Disconnect the Full Open Switch connector.
Measure the resistance between ground and the Full Open Switch circuit.
Is the resistance below 1000.0 ohms?
Yes → Repair the Full Open Switch Sense wire for a short to ground.
→ Go To 8
No
8
If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Replace the Full Open Switch (Lower Drive Unit).
Perform BODY VERIFICATION TEST - VER 1.
870
APPLICABILITY
All
All
Advertisement
Table of Contents
