Chrysler Town and Country 2003 Owner's Manual page 162

AIRBAG
PASSENGER SQUIB 1 CIRCUIT OPEN —
TEST
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger Airbag connector(s).
NOTE: Check connectors - Clean and repair as necessary.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Connect the Load Tool to the Passenger Airbag connector(s).
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag Control Module DTC's.
Does the DRBIII show PASSENGER SQUIB 1 CIRCUIT OPEN?
Yes → Go To 3
→ Replace the Passenger Airbag in accordance with the Service
No
3 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Load Tool from the Passenger Airbag connector(s).
Disconnect the Airbag Control module connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Connect the Load Tool ACM Adaptor to the Airbag Control Module connector(s).
Measure the resistance of the Passenger Squib 1 Line 1 and Line 2 circuit between
the ACM Adaptor and the Passenger Airbag connector.
Is the resistance below 1.0 ohms on both circuits?
Yes → Replace the Airbag Control Module in accordance with Service
→ Repair open or high resistance in Passenger Squib 1 Line 1 or
No
ACTION
Information.
Perform AIRBAG VERIFICATION TEST - VER 1.
Instructions. WARNING: IF THE AIRBAG CONTROL MODULE
IS DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST - VER 1.
Line 2 circuits.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
138
APPLICABILITY
All
All