Chrysler Town and Country 2003 Owner's Manual page 704

MEMORY SEAT
FRONT RISER SENSOR OUT OF RANGE LOW —
TEST
8 Turn ignition off.
Disconnect the Memory Seat Mirror Module C2 connector.
Disconnect the Driver Power Seat Front Riser Position Sensor connector.
Measure the resistance of the Seat Sensor 5 Volt Supply wire between the Front Riser
Sensor connector and the C2 connector.
Is the resistance below 5.0 ohms?
Yes → Go To 9
→ Repair the Seat Sensor 5 Volt Supply circuit for an open.
No
9 If there are no possible cause remaining, view repair.
Repair
ACTION
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Replace the Memory Seat Mirror Module.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Continued
680
APPLICABILITY
All
All