Chrysler Town and Country 2003 Owner's Manual page 409

*NO RESPONSE FROM LEFT SLIDING DOOR CONTROL MODULE —
Continued
TEST
6 Turn the ignition off.
Disconnect the Body Control Module C3 harness connector.
Disconnect the Left Sliding Door Control Module C2 harness connector.
Measure the resistance between ground and the Left Sliding Door Wake Up Signal
circuit.
Is the resistance below 100.0 ohms?
Yes → Repair the Left Sliding Door Wake Up Signal wire for a short to
→ Go To 7
No
7 If there are no possible causes remaining, view repair.
Repair
8 Turn the ignition off.
Disconnect the Body Control Module C3 harness connector.
Disconnect the Left Sliding Door Control Module C2 harness connector.
Measure the resistance of the Left Sliding Door Wake Up Signal circuit between the
BCM C3 connector and the Left Sliding Door Control Module C2 connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module in accordance with the service
→ Repair the Left Sliding Door Wake Up Signal wire for an open.
No
ACTION
ground.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Left Sliding Door Control Module in accordance with
the service information.
Perform BODY VERIFICATION TEST - VER 1.
information.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
385
COMMUNICATION
APPLICABILITY
All
All
All