HORN RELAY OPEN —
TEST
3
Turn the ignition off.
Remove the Horn Relay from the Fuse and Relay Center.
Disconnect the Front Control Module from the Fuse and Relay Center.
Measure the resistance of the Horn Relay Control circuit between the FCM connector
cavity 10 and the Horn Relay connector cavity 85.
Is the resistance below 5.0 ohms?
Yes → Replace the Front Control Module.
→ Replace the Fuse and Relay Center.
No
Continued
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
IGNITION, POWER, ACCESSORY
601
APPLICABILITY
All