Chrysler Town and Country 2003 Owner's Manual page 845

INCOMPLETE POWER CLOSE - HALL EFFECT SIGNAL MISSING —
Continued
TEST
8 Disconnect the Power Liftgate Motor connector.
Disconnect the Power Liftgate Module C2 connector.
Measure the resistance of the Liftgate Hall Effect Signal circuit between the Power
Liftgate Motor connector and the Power Liftgate Module C2 connector.
Is the resistance below 5.0 ohms?
Yes → Go To 9
→ Repair the Liftgate Hall Effect Signal wire for an open.
No
9 Disconnect the Power Liftgate Motor connector.
Disconnect the Power Liftgate Module C2 connector.
Measure the resistance between ground and the Liftgate Hall Effect Signal circuit.
Is the resistance below 100.0 ohms?
Yes → Repair the Liftgate Hall Effect Signal wire for a short to ground.
→ Go To 10
No
10 Disconnect the Power Liftgate Motor connector.
Disconnect the Power Liftgate Module C2 connector.
Measure the resistance between the Ground circuit (cavity 20) and the Liftgate Hall
Effect Signal circuit.
Is the resistance below 1000.0 ohms?
Yes → Repair the Liftgate Hall Effect Signal wire for a short to the
→ Go To 11
No
11 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Ground circuit.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Power Liftgate Motor Assembly (hall effect switch).
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - LIFTGATE
821
APPLICABILITY
All
All
All
All