Chrysler Town and Country 2003 Owner's Manual page 831

INCOMPLETE LATCH CINCH - OVERCURRENT —
TEST
7 Turn the ignition off.
Disconnect the Power Liftgate Module C2 connector.
Disconnect the Liftgate Cinch/Release Motor connector.
Measure the resistance between ground and the Liftgate Latch Release Driver
circuit.
Wiggle the harness and check for an intermittent short condition.
Is the resistance below 1000.0 ohms?
Yes → Go To 8
→ Repair the Liftgate Latch Release Driver wire for a short to
No
8 Turn the ignition off.
Disconnect the Power Liftgate Module C2 connector.
Disconnect the Liftgate Cinch/Release Motor connector.
Measure the resistance between the Ground circuit (cavity 20) and the Liftgate Latch
Release Driver circuit.
Wiggle the harness and check for an intermittent short condition.
Is the resistance below 1000.0 ohms?
Yes → Go To 9
→ Repair the Liftgate Latch Release Driver wire for a short to the
No
9 If there are no possible causes remaining, view repair.
Repair
ACTION
ground.
Perform BODY VERIFICATION TEST - VER 1.
Ground circuit.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Latch Assembly.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - LIFTGATE
807
Continued
APPLICABILITY
All
All
All