FRONT WASH SWITCH INPUT STUCK —
TEST
4
Turn the ignition on.
With the DRBIII , erase all BCM and FCM DTCs.
Turn the ignition off.
NOTE: Visually inspect the related wiring harness and circuits. Look for
any chafed, pierced, pinched, or partially broken wires.
NOTE: Visually inspect the related wiring harness connectors. Look for
broken, bent, pushed out, or corroded terminals.
Note: Refer to any Technical Service Bulletins (TSB) that may apply.
Were any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
WINDSHIELD WIPER & WASHER
Continued
975
APPLICABILITY
All