Chrysler Town and Country 2003 Owner's Manual page 923

INCOMPLETE POWER OPEN - EXCESSIVE HALL EFFECT SIGNAL —
Continued
TEST
8 Disconnect the Sliding Door Motor connector.
Disconnect the Sliding Door Control Module C2 connector.
Measure the resistance of the Door Motor Hall Effect Signal circuit between the
Sliding Door Motor connector and the PSD Module C2 connector.
Is the resistance below 5.0 ohms?
Yes → Go To 9
→ Repair the Door Motor Hall Effect Signal wire for an open.
No
9 Disconnect the Sliding Door Motor connector.
Disconnect the Sliding Door Control Module C2 connector.
Measure the resistance between ground and the Door Motor Hall Effect Signal
circuit.
Is the resistance below 100.0 ohms?
Yes → Repair the Door Motor Hall Effect Signal wire for a short to
→ Go To 10
No
10 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Power Sliding Door Motor Assembly (hall effect
sensor).
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - SLIDING
899
APPLICABILITY
All
All
All