Table of Contents
Advertisement
POWER DOORS - SLIDING
Symptom:
INCOMPLETE LATCH RELEASE- OVERCURRENT
When Monitored and Set Condition:
INCOMPLETE LATCH RELEASE- OVERCURRENT
When Monitored: Whenever the power sliding door is operating in the closing direction.
Set Condition: The latch motor stall current of 6.2 amps was detected during a
non-redundant release. The main causes of this code setting is some type of blockage
during the release. This code is set during the power closing operation.
DTC PRESENT
BINDING DOOR
FULL OPEN SWITCH STUCK
LATCH ASSEMBLY
TEST
1
With the DRBIII , record and erase DTC's.
Turn the ignition off, wait 10 seconds, then turn the ignition on.
Operate the power sliding door several times if possible.
With the DRBIII , read ACTIVE DTCs.
Does the DRBIII display INCOMPLETE LATCH RELEASE - OVER CURRENT?
Yes → Go To 2
→ Using the wiring diagram/schematic as a guide, inspect the
No
2
Examine the door for proper fit and alignment, lose/ hard or torn seals, worn teeth on
the rack and gear (lower drive unit) or anything that would cause an obstruction to
proper operation.
Manually operate the other sliding door or of a known good vehicle and notice the
effort needed to open and close.
Compare the effort needed on the disabled door.
Especially notice the effort needed to unlatch and close the door.
Does it take more effort to operate the door than it should?
Yes → Refer to Service information for the related symptom(S).
→ Go To 3
No
POSSIBLE CAUSES
ACTION
wiring and connectors for an intermittent condition. Operate the
door several times and check for any binding or other obstruc-
tions.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
874
APPLICABILITY
All
All
Advertisement
Table of Contents
