Table of Contents
Advertisement
POWER DOORS - SLIDING
INCOMPLETE POWER OPEN - LATCH FAILURE —
TEST
17
Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Cinch/Release Motor connector.
Measure the resistance of the Cinch/Release Motor Unlatch Driver circuit between
the Sliding Door Control Module C2 connector and the Cinch/Release Motor connec-
tor.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 5.0 ohms?
Yes → Go To 18
→ Repair the Cinch/Release Motor Unlatch Driver wire for an open.
No
18
If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Replace the Latch Assembly.
Perform BODY VERIFICATION TEST - VER 1.
904
Continued
APPLICABILITY
All
All
Advertisement
Table of Contents
