Left Rear Turn Signal Output Short - Chrysler Town and Country 2003 Owner's Manual

Table of Contents

Advertisement

EXTERIOR LIGHTING
Symptom:

LEFT REAR TURN SIGNAL OUTPUT SHORT

When Monitored and Set Condition:
LEFT REAR TURN SIGNAL OUTPUT SHORT
When Monitored: Ignition and left turn signal On.
Set Condition: When output voltage status is Low.
INTERMITTENT CONDITION
LEFT REAR TURN SIGNAL DRIVER CIRCUIT SHORT TO GROUND
TURN SIGNAL LAMP
BODY CONTROL MODULE
TEST
1
Turn the ignition on.
With the DRBIII , clear all BCM DTC's.
Actuate the Turn Signals.
With the DRBIII , read the DTC information.
Does the DRBIII read: Left Rear Turn Signal Output Short?
Yes → Go To 2
No
2
Turn the ignition off.
Disconnect the Left Rear Turn Signal Lamp connector.
Disconnect the BCM harness connector.
Measure the resistance between the Left Rear Turn Signal Driver circuit and ground.
Is the resistance below 100.0 ohms?
Yes → Repair the Left Rear Turn Signal Driver circuit for a short to
No
POSSIBLE CAUSES
ACTION
→ The condition that caused the symptom is currently not present.
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced,pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
→ Go To 3
472
APPLICABILITY
All
All

Advertisement

Table of Contents
loading

This manual is also suitable for:

Voyager 2003Caravan 2003

Table of Contents