Chrysler Town and Country 2003 Owner's Manual page 122

AIRBAG
LOSS OF IGNITION RUN - START —
TEST
9 Disconnect the Airbag Control Module connector.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool ACM Adaptor to the Airbag Control Module
connector.
Measure the resistance of the ORC Run - Start Driver circuit between the IPM C7
connector and ground.
Is the resistance below 500K ohms?
Yes → Repair the ORC Run - Start Driver circuit shorted to ground.
→ Replace the Airbag Control Module in accordance with Service
No
10 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: IF THE SIDE IMPACT AIRBAG CONTROL MODULE IS
DROPPED AT ANY TIME, IT MUST BE REPLACED.
Disconnect the Left Side Impact Airbag Control Module.
NOTE: Check connectors - Clean and repair as necessary.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
NOTE: When the ignition key is turned off, the FCM will supply a diagnostic
voltage to the SIACM Run-Start Driver circuit for approximately 60 sec-
onds.
Turn the ignition off.
Measure the diagnostic voltage of the SIACM Run - Start Driver circuit between the
Left Side Impact Airbag Control Module connector and ground.
Select the results from the list below?
Is the voltage between 1.0 and 2.2 volts
Is the voltage between 2.4 and 5.0 volts
No Voltage present?
ACTION
Perform AIRBAG VERIFICATION TEST - VER 1.
Instructions. WARNING: make sure the battery is disconnected
and wait 2 minutes before proceeding.
Perform AIRBAG VERIFICATION TEST - VER 1.
Replace the Front Control Module.
Perform AIRBAG VERIFICATION TEST - VER 1.
Go To 11
Go To 12
Continued
98
APPLICABILITY
All
All