Module Not Configured For Sab - Chrysler Town and Country 2003 Owner's Manual

AIRBAG
Symptom:

MODULE NOT CONFIGURED FOR SAB

When Monitored and Set Condition:
MODULE NOT CONFIGURED FOR SAB
When Monitored: With ignition on, the ORC monitors the PCI Bus for a message
containing an A in the 4 th position of the VIN. This character identifies the type of safety
equipment and should match the VIN. The PCM transmits the VIN every 3.5 seconds.
Set Condition: The code will set, if the ORC detects a Side Impact Airbag Module active
on the PCI Bus and the 4 th character of the VIN message is not an A .
PCM, PCI COMMUNICATION FAILURE
CHECK PCM VIN
STORED CODE OR INTERMITTENT CONDITION
ACM, ORC NOT CONFIGURED FOR SIDE AIRBAGS
ACTIVE CODE PRESENT
TEST
1 NOTE: Ensure that the battery is fully charged.
Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 Turn the ignition on.
Connect the DRB to the data link connector and select PASSIVE RESTRAINTS,
AIRBAG, SYSTEM TEST
With the DRBIII , read the PCM Active on the Bus
Does the DRB show PCM Active on the Bus:?
Yes → Go To 3
→ Refer to category COMMUNICATION and select the related
No
POSSIBLE CAUSES
ACTION
Go To 2
Go To 5
symptom.
Perform AIRBAG VERIFICATION TEST - VER 1.
108
APPLICABILITY
All
All