REAR RISER SENSOR OUT OF RANGE HIGH —
TEST
8
Turn ignition off.
Disconnect the Memory Seat Mirror Module C2 connector.
Disconnect the Driver Power Seat Rear Riser Position Sensor connector.
Measure the resistance of the Seat Position Sensor Ground wire between the Rear
Riser Sensor connector and the C2 connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Memory Seat Mirror Module.
No
ACTION
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
→ Repair the open Seat Sensor Ground wire.
Perform MEMORY SYSTEM VERIFICATION TEST - VER 1.
Continued
711
MEMORY SEAT
APPLICABILITY
All