Incomplete Power Open - Full Open Switch Failure - Chrysler Town and Country 2003 Owner's Manual

Symptom:

INCOMPLETE POWER OPEN - FULL OPEN SWITCH FAILURE

When Monitored and Set Condition:
INCOMPLETE POWER OPEN - FULL OPEN SWITCH FAILURE
When Monitored: Whenever the power sliding door is operating in the opening direction.
Set Condition: The Full Open Switch was detected as closed before 200 hall effect pulses
were counted since the start of the open operation.
DTC PRESENT
STICKING CABLES OR SWITCH
FULL OPEN SWITCH SENSE CIRCUIT SHORT TO GROUND
FULL OPEN SWITCH
TEST
1 With the DRBIII , record and erase DTC's.
Turn the ignition off, wait 10 seconds, then turn the ignition on.
Operate the power sliding door several times if possible.
With the DRBIII , read ACTIVE DTCs.
Does the DRBIII display INCOMPLETE POWER OPEN - FULL OPEN SWITCH
FAILURE?
Yes → Go To 2
→ Using the wiring diagram/schematic as a guide, inspect the
No
2 Examine the door for proper fit and alignment, foreign material in the lower drive
unit or anything that would cause an obstruction to proper operation of the Full Open
Switch.
With the DRBIII in Inputs/Outputs, read the FULL OPEN SWITCH state.
Manually operate the door handle while monitoring the DRBIII .
Does the switch status change smoothly as the handle is pulled and released?
Yes → Go To 3
→ Refer to Service information for the related symptom(S).
No
POSSIBLE CAUSES
ACTION
wiring and connectors for an intermittent condition. Operate the
door several times and check for any binding cables or other
obstructions.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - SLIDING
895
APPLICABILITY
All
All