Chrysler Town and Country 2003 Owner's Manual page 962

POWER MIRROR
UNFOLD MIRROR OUTPUT FAILURE (EXPORT ONLY) —
TEST
8 Disconnect the Left and Right Power Mirror connectors.
Disconnect the Body Control Module C2 connector.
NOTE: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Driver Folding Mirror Fold Driver
circuit in the BCM C2 connector.
Is the resistance below 5.0 ohms?
Yes → Repair the Driver Folding Mirror Fold Driver circuit for a short to
→ Go To 9
No
9 Disconnect the Left and Right Power Mirror connectors.
Disconnect the Passenger Folding Mirror Relay.
NOTE: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Passenger Folding Mirror Relay
Output circuit in the relay connector.
Is the resistance below 5.0 ohms?
Yes → Repair the Passenger Folding Mirror Relay Output circuit for a
→ Go To 10
No
10 Disconnect the Body Control Module C2 connector.
Disconnect the Passenger Folding Mirror Relay.
NOTE: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Passenger Folding Mirror Relay
Input circuit in the relay connector.
Is the resistance below 5.0 ohms?
Yes → Repair the Passenger Folding Mirror Relay Input circuit for a
→ Replace the Body Control Module.
No
ACTION
ground.
Perform BODY VERIFICATION TEST - VER 1.
short to ground.
Perform BODY VERIFICATION TEST - VER 1.
short to ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
938
Continued
APPLICABILITY
All
All
All