Chrysler Town and Country 2003 Owner's Manual page 674

INSTRUMENT CLUSTER
PANEL DIMMING OUTPUT SHORT —
TEST
15 Turn the ignition off to the lock position.
Disconnect the Body Control Module harness connector.
Disconnect the Radio harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Radio Dimming circuit.
Is the resistance below 5.0 ohms?
Yes → Repair the Radio Dimming circuit for a short to ground.
→ Go To 16
No
16 If there are no possible causes remaining, view repair.
Repair
17 The conditions necessary to set this DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this
circuit.
Wiggle the wiring while checking for shorts and open circuits.
Were there any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Continued
650
APPLICABILITY
All
All
All