Chrysler Town and Country 2003 Owner's Manual page 939

LEFT B-PILLAR SWITCH INPUT OPEN OR SHORT TO VOLTAGE —
Continued
TEST
4 Disconnect the B-Pillar Switch connector.
Using a 12-volt test light connected to 12-volts, check the Ground circuit in the
B-Pillar Switch connector.
Does the test light illuminate brightly?
Yes → Go To 5
→ Repair the Ground circuit for an open.
No
5 Disconnect the Body Control Module C3 connector.
Disconnect the Left B-Pillar Switch connector.
Measure the resistance of the Left Sliding Door Pillar Switch Mux circuit between
the BCM C3 connector and the Left B-Pillar Switch connector.
Is the resistance below 5.0 ohms?
Yes → Go To 6
→ Repair the Left Sliding Door Pillar Switch Mux wire for an open.
No
6 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Replace the B-Pillar Switch.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - SLIDING
915
APPLICABILITY
All
All
All