Chrysler Town and Country 2003 Owner's Manual page 507

RIGHT FRONT TURN SIGNAL OUTPUT OPEN —
TEST
3 Turn the ignition off.
Disconnect the Right Front Turn Signal Lamp connector.
Turn the ignition on.
Turn the Right Turn Signal on.
Using a 12-volt test light connected to ground, check the Right Front Turn Signal
Output circuit.
Does the test light illuminate brightly?
Yes → Replace the Turn Signal Lamp.
→ Go To 4
No
4 Turn the ignition off.
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Right Front Turn Signal Driver Circuit to ground.
Is the resistance above 5.0 ohms?
Yes → Repair the Right Front Turn Signal Driver Circuit for an open
→ Go To 5
No
5 Turn the ignition off.
Disconnect the Body Control Module C2 harness connector.
Disconnect the IPM C8 harness connector.
Measure the resistance of the Right Front Turn Signal Driver Circuit and ground.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module.
→ Replace the Intelligent Power Module.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
condition.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
EXTERIOR LIGHTING
Continued
483
APPLICABILITY
All
All
All