Chrysler Town and Country 2003 Owner's Manual page 499

LEFT SIDE PARK LAMP OPEN —
TEST
3 Turn the ignition off.
Disconnect the left front park lamp connector.
Turn the ignition on.
Turn the Park Lamps on.
Using a 12-volt test light connected to ground, check the Park Lamp Output circuit.
Does the test light illuminate brightly?
Yes → Replace the Park Lamp.
→ Go To 4
No
4 Turn the ignition off.
Check the IPM Park Lamp Fuse #2.
Is the Fuse open?
Yes → Replace the Park Lamp Fuse #2.
→ Go To 5
No
5 Turn the ignition off.
Install a known good relay in place of the Park Lamp Relay.
Turn the Park Lamps on.
Do the Park Lamps operate normally?
Yes → Replace the Park Lamp Relay.
→ Go To 6
No
6 Turn the ignition off.
Disconnect the IPM harness connector.
Measure the resistance of the Park Lamp Output Circuit to ground.
Is the resistance below 5.0 ohms?
Yes → Repair the Park Lamp Output Circuit for an open condition.
→ Go To 7
No
7 Turn the ignition off.
Remove the Park Lamp Relay.
Measure the voltage of the Fused B+ circuit of the Park Lamp Relay.
Is the voltage above 10.0 volts?
Yes → Replace the Front Control Module.
→ Replace the Intelligent Power Module.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
EXTERIOR LIGHTING
Continued
475
APPLICABILITY
All
All
All
All
All