Chrysler Town and Country 2003 Owner's Manual page 915

INCOMPLETE POWER CLOSE - OVERCURRENT —
TEST
3 Turn the ignition off.
Disconnect the Sliding Door Control Module C1 connector.
Using a 12-volt test light connected to 12-volts, check the Ground circuit.
Wiggle the harness and check for an intermittent open condition.
Does the test light illuminate brightly?
Yes → Go To 4
→ Repair the Ground circuit for an open.
No
4 Turn the ignition off.
Disconnect the Sliding Door Control Module C1 connector.
Measure the resistance between ground and the Sliding Door Close Driver circuit.
Wiggle the harness and check for an intermittent short circuit condition.
Is the resistance below 1000.0 ohms?
Yes → Repair the Sliding Door Close Driver circuit for a short to ground.
→ Go To 5
No
5 Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Measure the resistance between ground and the Cinch/Release Motor Unlatch Driver
circuit.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 1000.0 ohms?
Yes → Repair the Cinch/Release Motor Unlatch Driver circuit for a short
→ Go To 6
No
6 Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Measure the resistance between ground and the Door Motor Clutch Driver circuit.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 5.0 ohms?
Yes → Repair the Door Motor Clutch Driver circuit for a short to ground.
→ Go To 7
No
7 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
to ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Power Sliding Door Motor/Clutch assembly.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - SLIDING
891
Continued
APPLICABILITY
All
All
All
All
All