Chrysler Town and Country 2003 Owner's Manual page 185

SEAT SQUIB CIRCUIT SHORT —
TEST
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Seat Airbag connector.
NOTE: Check connectors - Clean repair as necessary.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED SEAT BACK PAD-
DED SIDE DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL
INTO THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN
SERIOUS OR FATAL INJURY.
Connect the appropriate Load Tool to the Seat Airbag connector.
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRB, read the SIACM active DTC's.
Does the DRB show SEAT SQUIB CIRCUIT SHORT?
Yes → Go To 3
→ Replace Seat Airbag in accordance with the Service Information.
No
3 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Side Impact Airbag Control Module connector
NOTE: Check connectors - Clean and repair as necessary.
If the SIACM connector is equipped with shorting clips or bars connect the
appropriate Airbag Load Tool Adapter to the connector.
Measure the resistance between the Seat Squib Line 1 and Line 2 circuits at the Seat
Airbag connector.
Is the resistance below 10K ohms?
Yes → Repair Seat Squib Line 1 shorted to Line 2 circuit.
→ Replace the Side Impact Airbag Control Module in accordance
No
Continued
ACTION
Perform AIRBAG VERIFICATION TEST - VER 1.
Perform AIRBAG VERIFICATION TEST - VER 1.
with Service Information. WARNING: IF THE SIDE IMPACT
AIRBAG CONTROL MODULE IS DROPPED AT ANY TIME, IT
MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST - VER 1.
161
AIRBAG
APPLICABILITY
All
All