No Odometer Message - Chrysler Town and Country 2003 Owner's Manual

AIRBAG
Symptom:

NO ODOMETER MESSAGE

When Monitored and Set Condition:
NO ODOMETER MESSAGE
When Monitored: With ignition on, the ACM monitors the PCI Bus for the Odometer
message from the Body Control Module. The PCM transmits the odometer message at 1
second intervals.
Set Condition: The code will set, if the ACM does not see the odometer message for 10
seconds.
PCM, PCI COMMUNICATION FAILURE
NO ODOMETER MESSAGE
STORED CODE OR INTERMITTENT CONDITION
ACM, NO ODOMETER MESSAGE
ACTIVE CODE PRESENT
TEST
1 NOTE: Ensure that the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
Turn the ignition on.
SELECT ACTIVE or STORED DTC:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 Connect the DRBIII to the data link connector and select PASSIVE RESTRAINTS,
AIRBAG, SYSTEM TEST.
With the DRBIII , read the PCM Active on the Bus:.
Does the DRB show PCM ACTIVE ON THE BUS?
Yes → Go To 3
No
POSSIBLE CAUSES
ACTION
Go To 2
Go To 5
→ Refer to category
COMMUNICATION CATEGORY and select
the related symptom.
Perform AIRBAG VERIFICATION TEST - VER 1.
114
APPLICABILITY
All
All