Symptom:
*NO RESPONSE FROM LEFT SLIDING DOOR CONTROL MODULE
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
PCI BUS CIRCUIT OPEN
LEFT SLIDING DOOR WAKE UP SIGNAL WIRE OPEN
LEFT SLIDING DOOR WAKE UP SIGNAL WIRE SHORT TO VOLTAGE
LEFT SLIDING DOOR WAKE UP SIGNAL WIRE SHORT TO GROUND
BODY CONTROL MODULE - LEFT SLIDING DOOR WAKE UP GROUND OPEN
LEFT SLIDING DOOR CONTROL MODULE - OPEN
TEST
1
Turn the ignition off.
Disconnect the Left Sliding Door Control Module C1 harness connector.
Measure the voltage of the Fused B(+) circuit.
Is the voltage above 10.0 volts?
Yes → Go To 2
→ Repair the Fused B(+) circuit for an open.
No
2
Turn the ignition off.
Disconnect the Left Sliding Door Control Module C1 harness connector.
Using a 12-volt test light connected to 12-volts, check the Ground circuit.
Does the test light illuminate brightly?
Yes → Go To 3
→ Repair the Ground circuit for an open.
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
383
COMMUNICATION
APPLICABILITY
All
All