Iod Wake Up Open - Psd - Chrysler Town and Country 2003 Owner's Manual

POWER DOORS - SLIDING
Symptom:

IOD WAKE UP OPEN - PSD

When Monitored and Set Condition:
IOD WAKE UP OPEN - PSD
When Monitored: Anytime the Body Control Module is awake.
Set Condition: If the BCM does not sense a signal circuit from the Sliding Door Module
this code will set.
DTC PRESENT
BODY CONTROL MODULE - IOD WAKE UP OPEN
SLIDING DOOR WAKE UP SIGNAL WIRE OPEN
LIFTGATE MODULE WAKE UP SIGNAL WIRE SHORT TO GROUND
SLIDING DOOR WAKE UP SIGNAL WIRE SHORT TO GROUND
SLIDING DOOR MODULE - IOD WAKE UP OPEN
TEST
1 With the DRBIII , record and erase DTC's.
Turn the ignition off, wait 10 seconds, then turn the ignition on.
Wait 10 seconds.
With the DRBIII , read DTCs.
Does the DRBIII display IOD WAKE UP OPEN?
Yes → Go To 2
→ Using the wiring diagram/schematic as a guide, inspect the
No
2 Disconnect the BCM C3 connector.
Measure the voltage between the appropriate Sliding Door Wake Up Signal circuit
and ground.
Is the voltage above 10.0 volts?
Yes → Replace the Body Control Module.
→ Go To 3
No
POSSIBLE CAUSES
ACTION
wiring and connectors for an intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
910
APPLICABILITY
All
All