Chrysler Town and Country 2003 Owner's Manual page 89

DRIVER SQUIB 1 CIRCUIT OPEN —
TEST
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Driver Airbag Squib connector(s).
NOTE: Check connectors - Clean and repair as necessary.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Connect the appropriate Load Tool to the Driver Airbag connector(s).
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag Control Module DTC's.
Does the DRBIII show DRIVER SQUIB 1 CIRCUIT OPEN?
Yes → Go To 3
→ Replace the Driver Airbag in accordance with the Service Infor-
No
3 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Load Tool from the Driver Airbag connector(s).
Disconnect the Clockspring connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Clockspring connector(s).
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag Control Module DTC's.
Does the DRBIII show DRIVER SQUIB 1 CIRCUIT OPEN?
Yes → Go To 4
→ Replace the Clockspring in accordance with the Service Informa-
No
4 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Load Tool from the Clockspring connector(s).
Disconnect the Airbag Control Module connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool Adaptor to the Airbag Control Module connec-
tor(s).
Measure the resistance of the Driver Squib 1 Line 1 and Line 2 circuits between the
ACM Adaptor and the Clockspring connector(s).
Is the resistance below 1.0 ohm on both circuits?
Yes → Replace the Airbag Control Module in accordance with Service
→ Repair open or high resistance in the Driver Squib 1 Line 1 or
No
ACTION
mation.
Perform AIRBAG VERIFICATION TEST - VER 1.
tion.
Perform AIRBAG VERIFICATION TEST - VER 1.
Information. WARNING: IF THE AIRBAG CONTROL MODULE
IS DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST - VER 1.
Line 2 circuits.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
65
AIRBAG
APPLICABILITY
All
All
All