Chrysler Town and Country 2003 Owner's Manual page 996

WINDSHIELD WIPER & WASHER
FR WIPER HI-LO RELAY OPEN —
TEST
5 Turn the ignition off.
Remove the Wiper Hi/Low Relay from the PDC.
Disconnect the FCM from the IPM.
Connect a jumper wire between the Wiper Hi/Low Relay Control circuit at the IPM
connector to ground.
Measure the resistance between ground and the Wiper Hi/Low Relay Control circuit
in the PDC.
Is the resistance below 5.0 ohms?
Yes → Replace the Front Control Module.
→ Repair the Wiper Hi/Low Relay Control circuit for an open.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Continued
972
APPLICABILITY
All