Passenger Seat Belt Switch Short To Ground - Chrysler Town and Country 2003 Owner's Manual

Symptom:

PASSENGER SEAT BELT SWITCH SHORT TO GROUND

When Monitored and Set Condition:
PASSENGER SEAT BELT SWITCH SHORT TO GROUND
When Monitored: The ACM monitors the Seat Belt Buckle Switch circuit for a shorted
together or shorted to ground condition.
Set Condition: The code will set if the ACM detects low circuit voltage.
PASSENGER SEAT BELT SWITCH SHORT TOGETHER OR TO GROUND
PASSENGER SEAT BELT SWITCH CIRCUITS SHORTED TOGETHER
PASSENGER SEAT BELT SWITCH CIRCUITS SHORTED TO GROUND
ACM, PASSENGER SEAT BELT SWITCH SHORT TO GROUND
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST
1 TURN THE IGNITION ON. THIS IS A TEST.
NOTE: Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 Turn Ignition off.
Disconnect the Passenger Seat Belt Switch connector.
NOTE: Check connectors - Clean and repair as necessary.
Turn Ignition on.
With the DRBIII , read the active Airbag Control Module DTC's.
Does the DRB show PASSENGER SBS CIRCUIT OPEN?
Yes → Replace the Passenger Seat Belt Switch Buckle Assembly.
No
POSSIBLE CAUSES
ACTION
Go To 2
Go To 5
Perform AIRBAG VERIFICATION TEST - VER 1.
→ Go To 3
127
AIRBAG
APPLICABILITY
All
All